Page 1 of 6
Burner
Posted: Thu Jan 24, 2008 6:28 pm
by tobyw7
Any recommendations?
Have been looking at the RM Model KL200, 80 or 100 W (£45) depending on what you read, or KL400 which is 200W (£115) but also quite a bit more expensive.
Haven't found many others to buy online.
Cheers
--Toby //
Posted: Fri Jan 25, 2008 8:36 am
by stampman
Posted: Fri Jan 25, 2008 4:13 pm
by tobyw7
yeah i was looking to do longer distance work.. thx
Posted: Fri Jan 25, 2008 4:46 pm
by stampman
Posted: Sat Jan 26, 2008 4:22 pm
by tobyw7
Cheers.. will take that into account..
Posted: Mon Jan 28, 2008 8:10 pm
by tobyw7
Will i be able to use a burner portable.. in a car,
without the battery going dead on me
?
Is it a safe thing to do..
Posted: Tue Jan 29, 2008 8:37 am
by stampman
Posted: Thu Jan 31, 2008 7:37 am
by tobyw7
Thanks for clarifying that.
Would the caravan split charger be the same as a split charge relay:
http://www.kampenwagen.co.uk/split%20charge%20relay.htm
-- Toby .
Posted: Thu Jan 31, 2008 8:41 am
by stampman
Posted: Thu Jan 31, 2008 3:43 pm
by tobyw7
Okay cheers.
Posted: Fri Feb 01, 2008 9:08 am
by stampman
Posted: Sun Feb 03, 2008 4:46 pm
by tobyw7
Yeah thank you. I think for the time being i'll have the rig set up for my car first. so i will only have to worry about the radio itself and the antenna
Then in a bit i'll organise an antenna of sorts at home etc
I'll let you all know how i get on anyway.
Re: Burner
Posted: Thu Mar 06, 2008 8:45 am
by simonthewizard
Run here the:
KL400
KL500
KL203
They are all working well and have never had any troubles with them, guess will do now.................... All seem to deliver the power well, and have small fans fitted on mine as helps with the heat, especially during the summer months
Re: Burner
Posted: Sat Mar 22, 2008 5:50 pm
by Apbuild
I have a KL 500.
Would a lack of power cause it not to work properly, ie, do I need to upgrade to a 40 amp power supply?
If I transmit from my office using no amp power, the signal is, of course clear as a bell in my jeep, some 100 yards away. As soon as the amp is turned on in the office, the transmission is lost altogether and all I get is a load of hiss.
Also, when the amp is on you can only TX for about three seconds before the rig restarts.
Any advice greatly accepted as usual.
Cheers,
Rob.
Re: Burner
Posted: Sun Mar 23, 2008 6:48 am
by stampman