Radio Discussion Community

ok fuel pump madde no difference.
a mate of mine has said that the imboliser could be doing it ?

tht was the plan to disconnect the fuel pump first!

ummm? where to start lol. mite start with fuel pump as it is one of the few things tht is on with the ignition

yes i can have the cb on with out the engine running. i have installed a bandit on the poer feed. a lo pass filter on the coax and have coiled the coax a few times at the base of the aireal as sugessed by a mate but it is still there. its getting to the point where it will be taken out again wich is ...

baught a power mic from our sponcers.
problem is it seams to be wired up wrong, hold the tx button and it doesnt transmit.
let it go and it does! (the oppsite to how u would normally use one)

how do i get this sorted? supressor on alternator? if so where and what one should i get?

but like i have explaned interference is only there when the centre pin on the coax is connected?

the radio. (goes off with the ignition but u can press the power button on the front and it comes on!

on the key

you can have it all off

(*) cig lighter on only

(*) iginition (glow plugs warm up)

(*) and start

like i said tho my mate connected it direct to batt and said it was noisey. swr is ...

engine off or on doesnt matter. a friend of mine tryed it from the batt. said it was just the same. but i will try it my self when i can!

no hands free kit in

ok thanks for the replies, now to sort out the main problem! (wish i had sorted it b4 i went on holiday

base coil only as the truck goes under trees and carparks. but like i said i dont want to go down the burner route (it is illagial after all and dont want to spoil every ones fun )

i am running a small orbitor on a gutter mount atm but i would like to get the optimum range for this set up drilling holes is not a option :( (to nice a truck)
but if u look in the 4x4 section u will see that i got other problems to sort! Grr lol

any way its not as simple as it used to be? so its ...

i have a intek m790 plus. a friend of mine told me that a twist of a screwdriver in the rig can increase the out put,

is this also possable on my rig? if so witch one do i adjust?

would like a bit more range but dont want to run a burner!

many thanks

it is in a discovery td5 auto 5 door. when the engine is running or not doesnt make a difference. (wired to go on and off with ignition)

got a disco td5, intek m790 plus (continatal package from here)

loads of interference

so far i have pulled out the coax connector from the back and put the squelch to no noise :D (laymans terms)
connected the outer part of the two together nothing then inserted the pin into it and loads of noise ...