Dual antenna quick release
Posted: Sat Nov 05, 2016 5:40 pm
Hi to all, second post (first in intro), looking for some advice on antenna installs.
My 4x4 is used in three ways.
First, running friends to and from functions so just a small minibus.
Second, weekend away camping off road, no roof rack, fridge and other basic gear.
And finally full on expedition prep, roof rack, RTT, spare, fuel blah blah.
I recently fitted an Albrecht AE 6110 CB, fits with some small mods in the space made when the ashtray is removed, I used a mag mount on the bonnet, SWR was easy and worked fine on a recent trip. The issues I had is the canyons where we were are very narrow and the foliage very unforgiving, it often snagged the Ariel and pulled it off, and some reception issues from vehicles behind, the rack and other gear probably killing the signal?
So, I fancy having two options. A permanent quick antenna release for the Ariel on the panel at the bottom of the windscreen, further in from the edge so less chance of being snagged, and another quick release on a metal plate mounted on top of the roof rack. And then have just the one Ariel that can be removed when running around during the week, and then fitted to the car or rack depending on planned trip.
The roof rack could be earthed to the body but I fancied one of those that have the false ground plane, but then is there one that has a quick release base?
Am I right that if I 'Y' the two cables into one and then into the radio, I may have trouble getting the SWR right, i.e. one quick release no Ariel, and one quick release with?
Or run two separate cables and only connect and SWR in the relevant one, or some kind of simple change over switch, which is my preference.
I am not a complete noob with CB's but it has been a few years to say the least so go easy on me.
TIA
regards
Dave
My 4x4 is used in three ways.
First, running friends to and from functions so just a small minibus.
Second, weekend away camping off road, no roof rack, fridge and other basic gear.
And finally full on expedition prep, roof rack, RTT, spare, fuel blah blah.
I recently fitted an Albrecht AE 6110 CB, fits with some small mods in the space made when the ashtray is removed, I used a mag mount on the bonnet, SWR was easy and worked fine on a recent trip. The issues I had is the canyons where we were are very narrow and the foliage very unforgiving, it often snagged the Ariel and pulled it off, and some reception issues from vehicles behind, the rack and other gear probably killing the signal?
So, I fancy having two options. A permanent quick antenna release for the Ariel on the panel at the bottom of the windscreen, further in from the edge so less chance of being snagged, and another quick release on a metal plate mounted on top of the roof rack. And then have just the one Ariel that can be removed when running around during the week, and then fitted to the car or rack depending on planned trip.
The roof rack could be earthed to the body but I fancied one of those that have the false ground plane, but then is there one that has a quick release base?
Am I right that if I 'Y' the two cables into one and then into the radio, I may have trouble getting the SWR right, i.e. one quick release no Ariel, and one quick release with?
Or run two separate cables and only connect and SWR in the relevant one, or some kind of simple change over switch, which is my preference.
I am not a complete noob with CB's but it has been a few years to say the least so go easy on me.
TIA
regards
Dave